Start a new topic

Pulled the pitop-ceed out of the closet

 I pulled it out the other day I was bored. I went to use it and found the Pi was disconnected from the MK1 hub . small Square board. there are 4 wires going over to the PI one on a single wire and the other three wires to one connector.


I can't find my docs to figure out where they go. I only figured out the power connection and it does work. I guess I dont need those other 4 wires :D



1 Comment

As long as you do not want to change the brightness of the pi-topCEED screen, it is indeed sufficient to just connect power and ground. If you want to adjust the brightness, you also need to connect the spi pins.
Login or Signup to post a comment